Instruction manual

Introduction
Page 18 Solution & Solution XL Operating Manual – Issue 1.0
Wheel LD and Control Wheels
Wheel LCD
The Wheel LCD is used to indicate which fixture parameters or other data are
being controlled by each of the three control wheels.
Example - When showing fixture parameter values - The Wheel LCD displays
the parameter name (eg Colour1) and the value in %, DMX or the parameter
detail name.
Tag status is shown by inverse graphics – a white background shows a
tagged parameter, and a blue background display shows an untagged
parameter.
Control Wheels
The three control wheels are used for setting fixture parameter levels and
other data. The names of the fixture parameters or other data currently
assigned to each of the wheels and their values is shown on the Wheel LCD.
Wheel Editing Modes
There are a number of wheel editing modes which apply when editing several
fixtures at the same time (Absolute, Relative, Fan First, Fan Middle, Fan Last,
Fan V).
For each attribute there is a normal wheel mode which applies when the
control wheel is moved and a shifted wheel mode which applies when the
SHIFT key is held down and the control wheel is moved.
For further details on each of the wheel editing modes, and how to adjust the
normal and shifted mode for each attribute – see page 85 of the manual for
full details.