Instruction manual

Setup
Solution & Solution XL Operating Manual – Issue 1.0 Page 51
Inputs
Press the [Inputs] MFK or select the [Inputs] button on the monitor. The various options are shown on the MFKs and monitor. These are summarised below:
Figure 36 - Desk Setup (Inputs)
 SMPTE Timecode – Enables the reception of SMPTE timecode at all
supported frame rates (24, 25, 30 Frames per Second).
 MIDI Timecode – Enables the reception of MIDI timecode at all supported
frame rates (24, 25, 30 Frames per Second).
 CAN – Disabled, iCAN or Chillinet.
Note –CAN functionality is not implemented in Version 7 software
 MIDI Notes – Defines which part of the desk the MIDI Notes can control.
Options are Channels, Submasters or Memories, together with settings for
which MIDI Channel and Octave to respond to.
 Remote Switches – Each of the six remote switches can be configured
as Disabled, GO, Go to Memory or Macro. If the action field is set to Go to
Memory or Macro, then an additional field is displayed allowing you to
enter the memory or macro number
 Submasters – Using these settings it is possible to define the maximum
number of submasters per page, upto 30. Each Submaster can then be
mapped to a DMX In channel, perhaps from another fader desk.
Tip: You can use an additional DMX Output universe to ‘map’ preset
faders to additional submasters if required. Using a short DMX cable,
link the output DMX Universe to the DMX In port. Repatch the channel
faders to this universe, and map them in Desk Setup / Inputs to
Submasters.
Note – SMPTE, MIDI, CAN and Remote Switches
These input functions are only applicable if the optional upgrade card
has been fitted to the Solution & Solution XL desk.