Instruction manual

Setup
Solution & Solution XL Operating Manual – Issue 1.0 Page 53
Behaviour
Press the [Behaviour] MFK or select the [Behaviour] button on the monitor. The various options are shown on the MFKs and monitor. These are summarised below:
Figure 38 - Desk Setup (Behaviour)
 Confirm Overwrites – When this option is set to Yes a confirmation
window will appear on the monitor screen when overwriting a memory,
submaster, palette, effect, macro etc.
 Recovery Mode – When the desk loses power and then has power
restored, should the desk recover to the last outputting
memory/submaster, or go to a blackout.
 Keep Parameters Separate
The Keep xxx Parameters Separate options are only applicable in Basic
Partial mode. If the options are set to „Yes‟ then each individual parameter
in that attribute will be tagged separately (eg in a CMY fixture, if Cyan is
adjusted, only Cyan will be tagged). If the attribute is set to „No‟ then as
soon as one parameter in that attribute is adjusted, all the parameters in
that attribute will be tagged automatically (eg in a CMY fixture, if Cyan is
adjusted, then Cyan, Magenta, Yellow and any other colour parameter for
the fixture will be tagged automatically).
 Preset Mixing – HTP = Highest Takes Precedence (in two preset mode,
if Preset A level is 40% and preset B level is 60%, the output level is
60%).
LTP = Latest Takes Precedence. Use the preset fader to match the
current output level for the dimmer. Once the level has been picked up,
you can adjust the level up or down using the fader. Note that when the
Preset Mixing is set to HTP mode, the preset faders are NOT shown in
the Program Window.