Instruction manual

Setup
Solution & Solution XL Operating Manual – Issue 1.0 Page 55
Memory Defaults
Press the [Memory Defaults] MFK or select the [Memory Defaults] button on the monitor. The various options are shown on the MFKs and monitor. These are
summarised below:
Figure 39 - Desk Setup (Memory Defaults)
 Intensity Delay Up/Down – defines the delay up and down time used for
intensities by default when a memory is recorded.
 Intensity Fade Up/Down - defines the fade up and down time used for
intensities by default when a memory is recorded.
 Colour Delay/Transition - defines the transition time used for colours by
default when a memory is recorded.
 Beamshape Delay/Transition - defines the transition time used for
beamshape by default when a memory is recorded.
 Position Delay/Transition - defines the transition time used for position
by default when a memory is recorded.
 Move on Dark – When a fixture is programmed at 0% intensity, the
memory stack will look ahead to find the next required position, colour and
beamshape, and automatically move the fixture to these values in
preparation for the fade up.
 Move on Dark Delay/Fade – The delay and fade times applied to the
above functionality. Note that these times apply from the completion of a
previous fade.
 Tracking – defines whether Tracking is enabled or disabled by default.
 Double Pause Mode - defines the behaviour of pushing Pause twice. It
can either „Go Minus‟ to the previous memory numerically, or „Go Back‟ to
the previous memory in the order you played them back.