Instruction manual

Setup
Page 56 Solution & Solution XL Operating Manual – Issue 1.0
Submaster Defaults
Press the [Submaster Defaults] MFK or select the [Submaster Defaults] button on the monitor. The options are shown on the MFKs and monitor. These are
summarised below:
Figure 40 - Desk Setup (Submaster Defaults)
 Flash Button Action – Flash, Solo, Latch, Go or Off
 Trigger Level Units – Percentage or DMX.
 Trigger Level – This is the point at which the moving light attribute
parameters are triggered on a submaster.
 Intensity Fade Up – the time used for intensities when the submaster is
raised
 Intensity Fade Down – the time used for intensities when the submaster
is lowered
 Colour Fade – the time used for colours when the submaster is
raised/lowered
 Beamshape Fade – the time used for beamshapes when the submaster
is raised/lowered
 Position Fade – the time used for positions when the submaster is
raised/lowered
 Submaster Controls … - These options determine which of the
attributes (Colour, Beamshape etc.) are controlled by the physical position
of the submaster fader :
Figure 41 - Submaster Controls...