Instruction manual

Setup
Solution & Solution XL Operating Manual – Issue 1.0 Page 59
Loading Shows
To load a show, connect the storage media to the USB port on the desk (any port). If you‟re using an external floppy drive, remember to insert the floppy disk into the
drive.
Press the [Files] MFK or select the [Files] button on the Setup Window.
Press the [Load Show] MFK or select the [Load Show] button on the monitor. The Load Show window is displayed on the monitor:
Figure 45 - Files (Load Show)
Select the required source device. A list of show files found on the selected
device is displayed in the window.
Select the required show file from the list (eg K-Nine Show 6).
Select the required Load Options. This defaults to Load Complete Show but
you can just load the Setup or Setup and Palettes if required.
Press the [OK] button to load the show.
Note – Loading Shows
Loading a show file will clear any existing show data from the desk so ensure
that you have backed up your previous show before you load another one
onto the desk.
Show files from a Solution desk can be loaded into a Solution XL and vice
versa.