Instruction manual

Setup
Solution & Solution XL Operating Manual – Issue 1.0 Page 73
WYSIWYG (http://www.castlighting.com)
WYSIWYG Requirements
 A current (Release 21 or greater) installation of WYSIWYG Perform
 The Zero 88 consoles file (provided on the Cast website)
 The Zero 88 WYSIWYG Driver (provided on the Zero 88 website, or on
the CD with the desk)
 An Ethernet connection to your Zero 88 console
WYSIWYG Installation
 First install WYSIWYG Release 22 or greater, following the standard
procedure (if you‟re using Release 21, you‟ll need the Zero 88 Consoles
CFB file)
 Run the Zero 88 WYSIWYG Driver installation tool
 Once the driver is installed, run the tool
 Select the network interface you wish to connect WYSIWYG with (the IP
address is shown)
 Choose OK
WYSIWYG Usage
 Start WYSIWYG & load your show file
 Patch your fixtures to Universes in WYSIWYG
 In the LIVE tab, select LIVE, Device Manager
 In Device Manager, select New and locate the
Zero 88 console you are connecting to
 Select the console and click Properties, then enter the IP address of the
desk in the Address. Select each Port on the desk and Bind these to a
Universe on WYSIWYG.
 In the Device Manager, click
CONNECT and the console
should connect. You can now
use WYSIWYG to visualise your
show.
 When you have finished
using it, click DISCONNECT in
the Device Manager.