Instruction manual

Preset Operation
Solution & Solution XL Operating Manual – Issue 1.0 Page 75
Preset Operation
Figure 60 - Preset Faders
The Solution desk has 48 preset faders which control 24 dimmer channels in
Two Preset mode or 48 dimmer channels in Wide mode.
The Solution XL desk has 96 preset faders which control 48 dimmer channels
in Two Preset mode or 96 dimmer channels in Wide mode.
The configuration and operation of the PRESET FADERS and the A MASTER
and B MASTER faders is determined by the operating mode of the desk, the
WIDE and PRESET CONTROL keys.
The Solution and Solution XL desks default to WIDE Mode operation.
You can switch the desk to operate into TWO PRESET operation using the
TWO PRESET (WIDE MODE) key on Special Page 1 of the MFKs or by
holding down the SHIFT key and pressing the PRESET CONTROL key.
The FLASH MODE key, which can be found on Special Page 1 of the MFKs
determines the operation of the CHANNEL FLASH buttons.
Crossfade Time - To enable timed fades there is an internal Fade Time that is
applied when crossfading between scenes in both Two Preset and Wide
modes. This internal fade time can be found and adjusted on Special Page 1
of the MFKs, labelled Time.
Two Preset Operation
Ensure that the GRAND MASTER fader is at full (100%) and BLACKOUT is
off.
Set the preset mode to TWO PRESET using the MFK on Special Page 1 or by
holding down the SHIFT key and pressing the PRESET CONTROL key.
Set the A MASTER and B MASTER faders to zero.
The internal Time should be set to 0.0seconds, on Special Page 1.