Instruction manual

Introduction
Solution & Solution XL Operating Manual – Issue 1.0 Page 9
Preset Controls
Preset Faders
The Solution desk has 48 preset faders arranged as two rows of 24 faders
and buttons. These control 24 dimmer channels in two preset mode or 48
dimmer channels in Wide mode.
The Solution XL desk has 96 preset faders arranged as two rows of 48 faders
and buttons. These control 48 dimmer channels in two preset mode or 96
dimmer channels in Wide mode.
Channel Flash Buttons
Each desk has a flash button located below each PRESET fader.
The CHANNEL FLASH buttons are used to flash, solo or latch the dimmer
channels or to select the channels or fixtures assigned to the corresponding
faders; their action being determined by the setting of the FLASH MODE
button in Special Page 1 of the MFKs.
A and B Master Faders
Two Preset Operation – The A MASTER fader controls the maximum output
levels from the PRESET A FADERS. The B MASTER fader controls the
maximum output levels from the PRESET B FADERS.
Wide Operation – The A MASTER and B MASTER faders control the
maximum output levels from all the PRESET faders or the stored scene
according to the setting on the PRESET CONTROL button.
Preset Control Button
The PRESET CONTROL button is only applicable in Wide Mode and is used
to control which of the A or B MASTER faders has control of the preset faders
and which has control over the stored scene. The red LEDs in the button
indicate the current state. Pressing the button swaps the function of the two
faders.