Installation guide

Zetadocs for NAV Installation Guide
This edition 5
th
December 2012 © Copyright Equisys plc 2012 All trademarks acknowledged All rights
reserved
Page 63
o For NAV 5 and 6 select AdministrationApplication SetupZetadocs SetupZetadocs
Document Queue Setup.
 Create a new queue record noting the No. allocated.
 Enter the rest of the details as shown below. Note that the Caption added here will be displayed to
the user when processing in the document queue and so it should give sufficient information to the
user about the action. However, when there is only one action it is performed by default.
Figure 23 - Document Queue Settings
11.7 Adding Document Queues to your NAV Menusuite NAV
To enable users to quickly access your document queues you can add them to your menusuite, to do this
simply follow the simple steps below.
 Open the object designer within NAV and select the menusuite option.
 Create a new menusuite or edit an existing one as per your requirements.
 If creating a new one select the New button and then select the Design level appropriate to your
install, e.g. Company.
 Locate the area in the Navigation pane where you wish to add the item to the menusuite.
 Right click on the area and select Create item.
 Select the object type of Form and pick the document queue in question from the object id field.
 Select OK when satisfied and the use ctrl+shift and the arrow keys to move your new item around
the menusuite until you are happy with its location.
 Press ctrl+s to save your changes.
 Repeat for any remaining document queues.
Note: Document Queues will not be available via the menusuite until you have closed and restarted NAV.