User manual

8
POWER PACK
ACTIVATION
See diagram opposite
a Your detector comes complete with an
integratedpowerpackthatwillprovide
power for its entire operational life. To
activatethepowerpackyouneedtopull
the disabling tab (see image). This will in
turn pull out the metal disabling clip, which
is attached to the end of the tab, from
thedisablingsocketwhichissituatedon
the underside of the detector. Retain the
disabling tab for future use by taping it to
page20ofthismanual.
b When the detector is activated the Power
LED will begin to flash green once every
minute to indicate that the detector is
receivingpowerfromthepowerpackand
is fully operational.
cTestthesounder,powerpackandcircuitry
by pressing and holding the centre of the
Test/Reset button briefly to confirm that
the detector is operating properly. The
sounder will sound as soon as the button is
pressed, and the Alarm LED will illuminate
redindicatingthatthesounderisworking
andthepowerpackisprovidingpower
to the unit. This test for the sounder, power
packandcircuitryshouldbeperformedon
aweeklybasis.Thisshouldbecontinued
for the lifetime of the product.
WARNING: Prolonged exposure to the
sounder in close proximity to your ears
may damage your hearing.
Under normal operating conditions, the power
packwilllastforthelifetimeoftheproductie.
7 years.
WARNING: Prolonged exposure to
temperatures outside those stated above
will reduce the power pack and sensor life.
Thedetectorwillnotprotectagainsttheriskof
carbon monoxide poisoning when the power
packhasdrained.