Specifications

Appendix C - ZlinkW Command Reference
226 025-9034AA
search search_string
filespec options
-l
-c
-t
Case-insensitive search for a string through specified file(s).
Filespec can contain wildcards; if no filespec is given, searches
current log file.
Stop searching the current file after the first match is found. Each
of the remaining files in the list is searched. This switch only
affects searching within a file.
Do a case sensitive comparison, where uppercase and lowercase
letters do not match.
Just print the total number of matches found in each file. Do not
list the actual lines containing the matches.
set filetype [filename]
filetypes:
options
trunks
network
oparam
Set operating conditions without rebooting. Filetype is as
follows; filename defaults to name shown if it is not specified:
Read the options.cus file & set parameters
Read the trunks.cus file & set parameters
Read the network.cus file & set parameters
Read the oparam.cds file & set parameters
siu
-a
-c
-m
-p
-q
-z
Displays the status of the station card(s).
Page Ages Pager Classes Message types Priorities SIU Queues
Zones
snap pagetask_name Diagnostic for gurus. Creates a file on the paging terminal with a
snapshot of the status of a given task. Find out task names with
the “tasks” command. Name must match name shown in “tasks”
list, except for leading/trailing spaces.
speed Diagnostic for Zetron engineers.
suspend Batch file command (ZlinkW local command)
tail filename n x Current systems: displays the tail end of filename for n lines.
Older systems or if “x” included: Makes a file on the office
computer named filetail that contains the last n lines of the paging
terminal file named filename. You can then type “dos type
filetail” to see filetail’s contents. Useful for looking at recent
events in log file.
Defaults: filename = current log file; n = 20.
tasks
-b
Diagnostic showing information about currently executing tasks
on the paging terminal.
Brief task list, one line per task
temp Shows temperature at paging terminal site, on some models.
time
hh:mmx
hh:mm:ssx
See and/or set the time of day on the paging terminal. Type
without options to just see the current time.
hours:minutesX, where X is a for am, p for pm
hours:minutes:secondsX, X is a for am, p for pm
Command
Options/
Parameters
Action