Specifications

Paging and PageSaver
38 025-9034AA
Announcement Mode Details
Announce mode can be Security Code protected. If you fill in a Security Code, that
Security Code will have to be entered before the Announcement is played.
If the subscriber changes their mode to Announce (6 on the main menu), and they do not
have an Announce mode custom prompt, they will be prompted to record their
Announcement - and if they do not record their Announcement, they will not be allowed
to change mode.
If a call comes to an Announce mode subscriber who does not have an Announce mode
custom welcome (despite the safeguard noted above, the subscriber can still come back
and delete the Announcement or not succeed in recording a replacement Announcement)
and the system Welcome prompt is not recorded, the system Thank you prompt will be
played, to allow for owner’s access to fix the situation. This is regardless of whether the
Thank you prompt was turned on in the database.
As a side effect of the above behavior, if an Announce mode subscriber has Thank you
programmed in ZbaseW, he or she will get a Thank you after the Announcement is played.
Voice Messages
As stated previously, voice messages for paging and/or mailboxes are stored by the Model
2100 and Model 2200 in the voice storage system. The stored messages are played over
the radio channel for paging or back over the phone during mailbox retrieval.
Dynamic Recorders and Pooled Storage
The innovative architecture of the Series 2000 Voice Storage subsystem provides high
capacity high throughput voice storage at a very reasonable cost. Unlike traditional voice
recording/playback systems, the Series 2000 has fully dynamic recorder channel
allocation to any trunk when needed. Also, the pooled voice storage memory means that
no recorder is incapacitated unless all of the memory is used up.
Voice Limits
The length of the voice message recording is determined by the Voice Limit field for each
subscriber in the Subscriber Database (see Managing the Subscriber Database with
ZbaseW on page 55). When the caller reaches the time limit, the terminal completes the
recording and sends the “Messages Accepted” prompt to the caller. A pager in the
database can have a Voice Limit from 0 seconds (for tone-only paging) to 255 seconds in
1-second steps.