Specifications

Edit Tab

is provided in the dialing string, the default baud rate of 4800 will be used. An entry in the

format of “Bxxxx” is used to set the baud rate used for the connection. The string “xxxx”

is a 4-digit number for the baud rate.

The string for specifying the baud rate and indicating that a local serial connection is in

use can be entered in two ways. You could type “B3840L” or you can type “L3840”. Both

strings are interpreted the same way by the ZlinkW communications software. The most

common setting for a local serial connection is B9600L.

If the paging terminal has been interfaced to an IP network, then this field holds the

network address for the terminal and the IP port number used to access the terminal. An

example of an acceptable entry would be:

010.0.1.22:2101

The colon (:) is the delimiter between the IP address and the 4-digit port number.

Port

This parameter is used to specify the serial communications port on the PC that is used

when a modem is used to communicate with the paging terminal. It refers to one of the

computer Com ports (for example, Com1 = 1, Com2 = 2, and so on). It is used for both the

modem and serial modes of operation. It is not required for a network connection.

B0300 = 300 baud B9600 = 9600 baud

B1200 = 1200 baud B1440 = 14,400 baud

B2400 = 2400 baud B1920 = 19,200 baud

B4800 = 4800 baud B3840 = 38,400 baud