Specifications

System Configuration Files
230 025-9035AA
Table 32: Station Card OPARAM Codes (continued)
(**) = default value for parameter
Meaning cc pp qq ...
Camp on busy zone 0A 2F byte 1 = Zone to program
byte 2,3 = Initial camp time for busy zone. 0-32000 sec,
0 = infinite, default = 0.
byte 4,5 = camp time increment for each subsequent
key attempt on a busy zone. 0-32000 sec,
default = 0.
byte 6,7 = maximum time to camp on a busy zone.
0-32000 sec, default = 300. Do not set to 0; make
sure >= to initial camp time.
byte 8,9 = time to wait until trying this zone again if it
was busy. 0-32000 sec, default=15.
Debug 01 17 None
Digital data polarity 02 06 00 = inverted data
01** = non-inverted data
DP6000 Parameter
version 1B2 and later
03 3C Byte 1 = Tone Burst Switching **default = 0,
0 = off, 1 = on
Byte 2 = The number of times to send the code block
**default = 1
FIFO Batch 02 3F 00 = Normal batch (**default)
01 = FIFO batch
FLEX Re-synchronize
Duration
02 3E nn = the number of cycles of emergency resync that
must be sent given an equivalent number of FLEX
Frames to fill with resync (the range is from 00 to
FF)
**default = 0F (hex) = 15 decimal
FLEX Zone 03 3D byte 1 = Set FLEX Zone (range is from 0 to 15)
byte 2 = FLEX Timer (range is from 1 to 3)
**default is that all FLEX Zones are disabled
Gap time 03 27 byte 1,2 = Gap time (TGAP) in ms between dropping
xPTT and raising yPTT during mode changes.
This time used to be controlled by Mode time.
Default is 00 FA (250ms). Mode time now
controls time from yPTT to data or audio.
Golay batching (obs) 02 0D nn = # seconds in batching period
default = 30 sec
Grant between pages 02 16 **00 = grant only on Terminal Busy input
nn = always drop TX after radio has been transmitting
more than nn minutes.