Specifications

233
OPARAM.CDS File
Table 32: Station Card OPARAM Codes (continued)
(**) = default value for parameter
Meaning cc pp qq ...
POCSAG mode 0A
02
26 1 = mode, 00 is normal POCSAG mode. **01 is high
reliable mode with warm-up.
2-3 = 512 baud warm-up frequency Hz. Default is 750
decimal.
4-5 = 512 baud warm-up # of bits to send. Default is
300 decimal.
6-7 = 1200 baud warm-up frequency Hz. Default is
1500 decimal.
8-9 = 1200 baud warm-up # of bits to transmit. Default
is 300 decimal.
(Alternate)
00 = normal POCSAG mode.
**01 = high reliable mode with warm-up.
POCSAG out of range
transmission zones
03 31 byte 1 = zone (00-0F)
byte 2 = 1-enable, 0-disable
Note: this is standard on a new station, a special on an
old station.
POCSAG out of range
transmissions.
05 30 byte 1 = range transmissions periodic rate in minutes
byte 2 = 512 baud 1-enable, 0-disable
byte 3 = 1200 baud 1-enable, 0-disable
byte 4 = 2400 baud 1-enable, 0-disable
Note: This is standard on a new station, a special on an
old station.
POCSAG repeat function
code
n+1 33 byte 1 = 0 if setting for numeric, 1 if alpha
byte 2 = (1-4) replaces function 1 for repeats
byte 3 = (1-4) replaces function 2 for repeats
byte 4 = (1-4) replaces function 3 for repeats
byte 5 = (1-4) replaces function 4 for repeats
Default: repeats use the same function as the primary
page.
POCSAG set system ID 05 38 nn nn nn... 20 bit system ID
Post Paging TX Hold Time 03 1C nn nn Transmitter hold time in ms. How long to wait
for a new incoming page before unkeying the
transmitter. Default: 100 msec
Priority multiplier 02 20 nn = multiplies the priority incremental time by 512 ms
for each increment of this value. 00 disables
priority operation. Default setting is 3B (59
decimal) for 30 seconds per increment of a
subscribers priority assignment.