Specifications

System Configuration Files
236 025-9035AA
Table 32: Station Card OPARAM Codes (continued)
(**) = default value for parameter
Meaning cc pp qq ...
Talkback parameters 08 1A byte 1 = # of rings maximum to mobile, 4 sec per ring,
5 rings default (20 seconds of alert time), 1 - 127
allowed
byte 2 = mobile activity timeout, 30 second default,
1 - 255 allowed, 0 for no timeout
byte 3 = call limit timeout, 10's of seconds to allows,
18 10's default (180 sec = 3 minutes), 1 - 255
10's of seconds allowed, 0 for not timeout
byte 4 = seconds before mobile activity time-out to start
warning beeps, 10 sec default, 0 - 255 allowed
byte 5 = 10's of seconds before call limit timeout to
start warning beeps, 2 10's of seconds default
(20 sec) 1 - 255 10's of seconds allowed
byte 6 = How to handle TX audio when COR is
present:
0 = silence out TX
1 = mobile voice out TX
2 = busy tone out TX (privacy mode)
3 = phone out TX when COR (for full duplex
talkback pagers)
byte 7 = 10ths of seconds to debounce COR before
considering the talkback pager to have
answered, 1 default, 0 - 10 allowed
TX grant time (TGRANT) 03 12 nn nn = # milliseconds transmitter goes away if busy
input true default = 3 seconds
TX key up delay time
(TKEY)
03 02 nn nn = # milliseconds to wait after keying AUX PTT
to keying ANA or DIG PTT.
(**default = 1 second)
Voice message beep 02 15 00 = no beep over radio after each voice msg
**01 = 1000 Hz beep after each voice message
Watchdog timeout 03 25 byte 1,2 = maximum time the transmitter may remain
keyed on a single authorization.
Authorization is granted at the start of
paging, talk time, mobile ringout, mobile
activity. 1 second per increment of this
value. Default is 012C (300 decimal). Use
FF FF (6500 seconds) to effectively disable
this.