Specifications

257
TAP Outdial OPARAM Codes
Modem-related Parameters
These are set once for the entire outdial TAP card, and apply to all destinations. All have a
maximum value of 255, or 25.5 seconds.
Table 38: Modem Related TAP Parameters
Meaning cc pp qq ...
Command Timeout 02 07 Byte 1 = Command Reply Timeout. Modem command reply
timeout, 0.1 sec units. How long to wait for the
modem to reply to a command. This is the maximum
time any non-dialing command should take to
complete. Default = 10 decimal (1 second).
Command Wait 02 0B Byte 1 = Inter-Command Wait. General command guard
time, 0.1 second units. After sending any command
except the reset command (i.e. ATZ) to the modem
wait this long before sending another command.
This value only takes effect if there is no expected
response string for the command sequence. The
default value is 2 seconds.
DTR Wait 02 08 Byte 1 = DTR Wait. DTR transition guard time, 0.1 second
units. How long to wait after changing DTR before
talking to the modem again. The default value is 1
second.
Guard Time 02 09 Byte 1 = Guard Time. Command escape sequence guard time
0.1 sec. Sets the “dead” time bracketing the sending
of the “enter command mode” string to the modem.
The default value is 1 second.
Reset Wait 02 0A Byte 1 = Reset Wait. Reset command guard time, 0.1 second
units After sending the modem the reset command
(i.e. ATZ) wait this long before sending another
command. The default value is 2 seconds.