Specifications

System Installation
26 025-9035AA
Installation Checklist
This installation checklist is provided as a “to do” list that will guide you through the steps
necessary to install the paging terminal and its operating software. Follow the steps in the
checklist to install the paging terminal.
This checklist consists of specific instructions, and in some instances, references to other
instructions contained in this manual. When a step in the installation checklist refers you
to another procedure in the manual, complete that procedure and then return to where you
left off in the checklist.
1. [_] Unpack and open the paging terminal cabinet.
Unpack the Model 2100/2200 from largest box (save the box).
Remove the front door (screw latches on Model 2200)
Remove the top cover (unscrew, slide toward you, and tilt up on the Model 2200;
on the Model 2100, remove 10 screws)
You can check your order against the received items.
2. [_] Complete step a or b, depending on the CPU option supplied with your system:
a. Install the hard disk card. (See Hard Disk Card Mounting Information on page
32, for more details.)
Unpack the hard disk card from shipping smaller box.
Remove the #4-40 screw from card slot #1. Figure 2-1 shows the location of
the hard disk card in the paging terminal.
Install the hard disk card and secure with the #4-40 screw.
No formatting is necessary.
b. Verify that the SCSI disk is mounted in the bottom section of the chassis.
(Refer to SCSI Disk Card Mounting Information (M2200) on page 32, for more
details.)
3. [_] Make sure all circuit cards, in each and every occupied slot, are firmly seated in
the paging terminal cabinet.
4. [_] The office computer that operates the paging terminal’s database can be
connected as a remote connection or a local connection. Depending on whether
you are installing a remote connection or a local connection, for the office
computer, perform either step a. or b.
Note For remote computer connection, the paging terminal is equipped
with a US Robotics 56 kbs modem, installed in the slot shown in the
paging terminal diagrams. This card allows communication with the
computer via a dial-up telephone line. For local computer
connection, the paging terminal is equipped with RS-232C serial
data capability. This allows communication with the computer via a
direct cable link.