Specifications

279
The “.CUS” Files
Table 38: Summary of Parameter Defaults (continued)
* These are not the “default if missing” values, but the values we currently use as defaults for new
terminals.
The following template can be added to options.cus if this special operation is needed.
Usable in ZPAGE 310g8 or later. When inserted in options.cus, this will enable generic
function code entry to be used such that a display message OR a voice message can be
entered by the caller, and a Motorola Keynote pager will be correctly alerted.
;
; OPTIONS.CUS - Generic function code setup for Golay Keynote pagers
;
; Function code table
;
FunctionCode 0 none
FunctionCode 1 voice
FunctionCode 2 none
FunctionCode 3 none
FunctionCode 4 none
FunctionCode 5 none
FunctionCode 6 none
FunctionCode 7 display
FunctionCode 8 none
FunctionCode 9 none
;
;
; Pagercodes table
; -- Generic Function Codes --
; type msgs 0 1 2 3 4 5 6 7 8 9
;
PagerCodes gsc tone 0 0 0 0 0 0 0 0 0 0
PagerCodes gsc voice 0 1 0 0 0 0 0 0 0 0
PagerCodes gsc display 0 0 0 0 0 0 0 7 0 0
PagerCodes gsc both 0 0 0 0 0 0 0 0 0 0
;
; note - all zeros in the above table correspond to impossible-to-reach
; entries
;
; note: in zlink -
; the fcode command will display the first table &
; the pagers command will display the second table
;
;
Command Default Value Notes
MaxOwners 4* 4 actions can be done in Owners mode
MaxRecycle OFF call recycling inactive
Notify Old IdNone act same as older systems
FastDTMF 2000 OneYes wait 2 seconds after “0”, support “1” overdial
FaultON FaultOff controls activation of Fault Relay
FileProbes CC 20 SDB 20 over 20 probes reported to log file
FollowForward PHONE ignore internal fwd on non-phone inputs
BlockIfSecurity PHONE security code blocks only phone inputs
NumericAllowAlpha YES alpha sent even to numeric pager
ValidDestAlways (none) inactive
GroupToValid (none) inactive