Specifications

System Installation
28 025-9035AA
5. [_] Plug the paging terminal unit into the appropriate AC power source and switch
on the power. On the Model 2200, the switch is located on the right-side panel; on
the Model 2100 the switch is located inside the front door of the cabinet.
6. [_] With power applied to the paging terminal, check front panel lights for correct
operation as described in Front Panel Lights on page 182.
7. [_] At this point, you can connect either the telephone lines designated for the
trunk cards of the paging terminal, or a test telephone that connects temporarily for
testing purposes.
Connect the telephone lines, or the test telephone, to the trunk card(s) via the
RJ2EX connectors on left side of the lower backplane shown in Figure 3 or Figure
4. Refer to TELCO Connectors on page 72 for specific connection information.
Refer to the configuration packet you received from Zetron along with the terminal
for information on how the telephone trunks were programmed at the factory.
Figure 3: Model 2200 Telephone and Transmitter Connectors
Figure 4: Model 2100 Telephone and Transmitter Connectors
Note If an expansion chassis is part of the system, the expansion chassis
must be powered up at the same time (or before) the main chassis
is powered up.
BACKPLANE
J19
TELEPHONE LINE
CONNECTORS
TRANSMITTER
CONNECTORS
J20 J21
J22
BACKPLANE
J13
TELEPHONE LINE
CONNECTORS
TRANSMITTER
CONNECTORS
J14