Specifications

System Configuration Files
280 025-9035AA
; Note, to date, the above mechanism has only been used for HSC and
; Keynote (Golay) pagers. However, it is now available for all formats.
; Where the string "gsc" is in the PagerCodes options.cus lines, the
; following can be used:
; 2tone
; 5tone
; POCSAG
; Golay
; GSC (gsc & golay are synonyms)
; HSC
; D3
;
; Remember - when generic function code processing is enabled via these
; options.cus lines, all caller entered function codes will receive
; generic processing - no matter what format the pager is. Thus this is
; usually only used on a system where function code dependent message
; entry occurs, and no other caller entered function code processing is
; needed. Unless a pager can do voice pages and display pages, the
; mechanism is not needed. Thus, at this point in time, the Shinwa POCSAG
; pagers would appear to be the only other candidate for this handling.
;
;
; 310h1 built-in Golay and POCSAG Voice-or-Display
; ------------------------------------------------
;
; The above was enhanced in version 310h1. Default tables for GSC and POCSAG
; are now built in. The 6f0 or later dual trunk code is needed, and system
; voice prompt 73 is needed.
;
;
; Golay
; -----
; If you program a Golay format pager with a voice limit and a display
; limit, the caller will be prompted for a voice message or a display
; message. Then whichever type of message is left will be sent to the
; pager.
;
; The function code that will be used for the page is as follows:
; function code in database: 0 1 2 3 4 5 6 7 8 9
; function code for voice: 8 3 0 1 6 7 4 5 2 3
; function code for display: 0 1 2 3 4 5 6 7 8 9
;
; Note that if Send Empty Message is YES, for Golay an empty message is
; always turned into a 1 character display message, so no tone only
; function code is needed.
;
; This mapping can be seen via zlink by running the "pagers" command.
; Just ignore the last column (10) which is seen on this display.
;
; In the M2000, if another mapping is desired, the "PagerCodes gsc voice"
; and "PagerCodes gsc display" lines can be used to set the mapping to
; whatever is desired. This might be needed if the sysop is doing generic
; function code processing as well as Golay voice or display.
;
;
; POCSAG
; ------
; If you program a POCSAG format pager with a voice limit and a display
; limit, AND a function code other than 4, the caller will be prompted for
; a voice message or a display message. Then whichever type of message is
; left will be sent to the pager.
;
; If you program with function code 4, the existing voice and display
; message collection and sending will result.
;
; The function code that will be used for the page is as follows:
; function code in database: 1 2 3 4
; function code for voice: 4 4 4 4
; function code for display: 1 2 3 4
; function code for tone: 1 2 3 4