Specifications
System Configuration Files
288 025-9035AA
LogOn tells the system to write a line to the log when the call starts showing the ANI.
(This can only occur if the trunk returns an ANI.)
PIon enables (PIoff disables) sending of the ANI in Paging and Insure modes. (All of the
conditions described for this option must be met for this keyword to function.)
NoteOn enables (NoteOff disables) the addition of the ANI to the PageNote in Notify
mode.
ANIsend LogOff can be used even if you have not purchased the ANI sending option. It
turns off the log entry with the ANI at the beginning of each call.
Channel / Zone
Channels and Zones are controlled with the Channel and Zone commands. These
commands allow the RF channel and zone values of pages to be selectively overridden on
a per-trunk line basis. The commands need at least one channel/zone control value. Each
of the channel/zone values corresponds to a channel/zone setting in a ZbaseW record. This
override information will be applied in a uniform fashion to Page, Notify, and Insure
pages. The allowed values are chosen from the set:
For example, the commands:
CHANNEL 1 2 * N
ZONE 5 6 * 8
would force a page to appear to have the following values, as it would appear in ZbaseW
format:
1/5 2/6 C/Z N/N
where C/Z is the Channel/Zone as it appears in the subscriber record of the current call.
Note that a “N” in either Channel or Zone of either the subscriber record or the trunk.cus
entry will block a page from that position in the Channel/Zone record.
Note The ANIsend Option requires MFR1 (in North America) or MFR2
(outside North America) digit feed to function correctly. Please
check with your local phone company before ordering this feature.
1...4 RF Channel, for the CHANNEL command
0...15 RF Zone, for the ZONE command
Override the corresponding position in the subscriber
database record. If the subscriber record has a “N” in this
position, then it will be inactive.
N Block all pages from this position, regardless of subscriber
record value.
* Use whatever value the subscriber record has in this
position. If the subscriber record has a “N” in this position,
then this position will be inactive.