Specifications

Remote Maintenance
334 025-9035AA
In revision 310J0, the “niu -s” command was extended to handle reporting for more
than one card. The status of each TNPP card is now listed separately. The command also
reports whether each card sends and/or receives pages (satellite cards can only accept
inbound pages).
ZlinkW “note”
Use the note command to display test and notification reminder pages. The display shows
the subscriber ID for the page and the type of page (test or Reminder). Then it displays the
remaining number of repeats and the interval between repeats, in seconds. After that
comes the wait from the previous page in the list until this page goes out (or delay until
sent for the leading page), and the total delay through the list. The last fields on the line are
the voice time and/or display message length, ending with any pre-set display message.
The display message does not show for reminders, which are generated each time the
reminder page is sent.
The display length shown is the maximum length as set in the subscriber's ZbaseW record.
This can be useful if a test page does not seem to have a proper display message generated
when the
-t or -c options were selected. As these options extend the length of the display
message, the resulting message could be too long and end up being sent to the pager
truncated, appearing as though the option was not working.
The voice time shown indicates the actual length of the selected voice file. Note that
problems may arise if the selected voice file is deleted while the test page is still active.
This could happen if a PageSaver file is selected and its time limit expires while the test
page is active, or if a temporary voice file (one starting with an "&") is selected.
Even if there are no active test or reminder pages, the settings of the system
Reminder
parameters will be displayed. For more information on the
Reminder parameters please
see the System Configuration Files section.
+ note
Repeat Delay
subscriber type remain interval delta total V D msg
0251 Test 250 240 27 28 20 0251
0259 Test 80 60 12 40 20 0259
0260 Test 196 60 0 40 20 0260
0257 Test 122 60 0 40 20 0257
0779 Test 213 540 40 80 6
0215 Test 216 10800 0 80
0123 Rem 217 240 5 85 20
1 Reminders 6 Test pages max wait 85 sec
system parameters are 7 repeats at an interval of 600 seconds,
time displayed in Hours
? - List ZLINK Commands
Typing a question mark (?) at the ZlinkW plus prompt will give a list of the current
ZlinkW commands.
+ ?
cards cpa cd chdir chsdb copy cp date
time del erase df dir get liu ls
loadcard log md messages mkdir move mv newsdb
note offline online post put q quit reboot