Specifications

Remote Maintenance
350 025-9035AA
“set” Command
The log file now posts all ZlinkW set commands. This allows the system operator to
check on any system configuration changes. Below are some examples of the
set
command, their results, and the corresponding log posts. (The first line is typed at the plus
(+) prompt, and the second line is the system response.)
Example 1
+ set options
Setting options with file 'OPTIONS.CUS'
+
The log file reporting for this command would be:
+19jan96 04:07:23p SetOptions processing file 'OPTIONS.CUS'
+19jan96 04:07:25p SetOptions processing of file 'OPTIONS.CUS'occurred
Example 2
+ set network
Setting network with file 'NETWORK.CUS'
+
The log file reporting for this command would be:
+19jan96 04:06:50p SetNetwork processing file 'NETWORK.CUS'
+19jan96 04:06:52p SetNetwork processing of file 'NETWORK.CUS'occurred
If no valid commands were found in the file being processed, the second line (in either
example) would have reported “did not occur” instead of “occurred”. Likewise, if the file
did not exist, the second line would have reported “could not be done” instead of
“occurred”.
Please note that the
set ASP command has not changed.
Note Additional information concerning the “set” command may be
found on page 320.