Specifications

Model 2200EX Installation

General

PLEASE READ BEFORE STARTING THE INSTALLATION

Installing the Model 2200EX will require approximately 15 minutes of down time on an

existing Model 2200. The required tools are a small Phillips screwdriver and a #6

nutdriver. The location of Model 2200EX components is shown in Figure 10.

If you have purchased new telephone or transmitter interface cards with your 2200EX,

you may need to contact Zetron Technical Support to have your system files updated to

support the new cards. You should have this done before starting on the hardware

installation. Please call Zetron Technical Support (at 425-820-6363) and ask for Series

2000 Paging Terminal support (at extension 490).

Due to changes in design of the Model 2200 “main chassis”, there are two different types

of Model 2200EX slotted top covers. If your chassis requires an older style top cover, you

should have received one of that type with your kit. If you did not receive the correct

cover, please call Zetron Technical Support (at 425-820-6363) and notify us of the

oversight. The correct cover will be sent to you.

• New Style Cover: Attaches with nine pan head screws.

• Old Style Cover: Attaches with two large thumbscrews, in front only

You should have received the following with your Model 2200EX kit:

Note The 2200EX installation requires the use of either the Zetron CPU

card (702-9176) or the Pentium CPU card (950-9633 / 950-0688).

QTY Description

1 Model 2200 Chassis

2 702-9204 EXPAND Cards (1 labeled “MASTER”, 1 labeled “SLAVE”)

1 Model 2200EX Interface Cable

1 Model 2200 Front Door

2 Slotted Top/Bottom Covers

6Lag Bolts

6Grommets

1 AC Power Cord

1 Old Style Slotted Top/Bottom (only if required to match older chassis)