Specifications

System Installation
40 025-9035AA
Model 2200EX Setup
♦ Setting up a Model 2200EX
1. Remove the front door of the 2200EX and remove all cards from the chassis. Using
the lag bolts and grommets provided in the kit, mount the 2200EX chassis to the
wall. Be careful to mount the chassis close enough to the 2200 main chassis that
the interface cable provided can connect the two units. Ensure that the lag bolts hit
studs in the wall to ensure a solid mounting for the new chassis.
2. Remove the top panel of the 2200EX chassis.
3. Verify that the SLAVE Expand card is configured as follows:
JP2 = Out
JP8 = Out
JP3 through JP7 = IN
JP1 = SNG/SLV position
4. Install the SLAVE Expand card in slot 5 of the 2200EX chassis.
5. Connect the “DUAL” connector end of the 2200EX chassis interface cable to the
SLAVE Expand card’s 68-pin female connector, labeled J2. This connector is
located at the top edge of the Expand card. Tighten the thumbscrews until the cable
connector is fully seated against the card connector.
6. Route the interface cable through the cutout in the top cover and replace the top
cover on the 2200EX chassis.
7. Install the new trunk/multiport/station cards in the 2200EX chassis. (See Figure
10)
Figure 10: Possible Locations for Model 2200EX Components
123 45 67 8 9 10111213141516
TRUNK CARDS
TRUNK or TAP-TNPP SERIAL CARDS
Model 2200 Expansion Chassis
POWER SUPPLY
EXPANSION
SLAVE CARD
TRUNK or STATION CARDS