Specifications

System Installation
50 025-9035AA
9. The following screen is displayed while the program saves the new settings to the
Digi One SP module. This process will take several minutes and the status bar will
reach the right side long before it is over. Be patient. You do not need to do
anything until the process is finished. The program will advance to the next screen
automatically.
10. The final screen confirms that you have successfully configured the Digi One SP
module to perform as a Incoming TCP Connection. Review the check boxes at the
bottom of the screen, select the ones you want or clear them all, and click on
FINISH.
The remaining programming to configure the modules will be accomplished by
connecting to each module directly by means of an ordinary browser.
Configuration Using a Browser
The final configuration of the Digi One module used to communicate with the paging
terminal is accomplished by logging onto the unit with a common Internet browser and
making the necessary changes. The easiest time to do this is right after you finish the first
phase of the module configuration using the tool provided by Digi International on CD-
ROM, while the module is still connected to the network.
For the purposes of this example, we will still be using the IP address information initially
presented in Table 2. The serial port settings for the unit is listed in Table 7.