Specifications

53
Configuring the Digi One™ SP Option
4. Click on the option Advanced Serial Settings. As shown in the following
window, configure the serial port parameters to match the settings listed in Table 3.
When you have finished, be sure to click on the Apply button before you leave this
window, otherwise none of the changes will be stored in the module.
5. This concludes the programming of the module. It must be rebooted before being
placed in service. You can do this by clicking on Reboot in the left column, or by
disconnecting the unit from the network and removing power from it.
If you choose to reboot the module later, select Logout from the column on the left
and close your browser.
Remove the loopback device from the serial connector on the Digi one SP module and use
the supplied serial cable to connect the serial port on the module to the local programming
port on the paging terminal.