Data Sheet

0.056 (1.42) REF to Sensitive Point
5.91±0.25 (150.0±6.4)
0.125
(3.18)
0.550
(13.97)
0.416 REF
(10.57)
0.175 (4.44) REF
0.130 (3.30)
0.305
(7.75)
Sensor Body is Glass-Filled Nylon
Leads 24 AWG
0.430 (10.93)
0.060
(1.5)
0.138
(3.5)
0.551 (14.0)
0.323
(8.2)
0.178
(4.51)
0.188
(4.78)
0.138
(
3.5
)
Magnet
1
3
4
VCC
(red)
Pull-up
Resistor
Output
(green)
Ground
(black)
MP1013 Series
Hall-effect position sensor with convenient snap-fi t mounting.
Features
 Solid state reliability
 Excellent output stability over operating temperature range
 Open Collector (NPN) output can be used with bipolar switch or
cmos logic circuits with suitable pull up resistor
 MP101301 – unipolar switch
- Output switches low (off) when the magnetic fi eld at the sensor
exceeds the operate point threshold.
- Output switches high (on) when the magnetic fi eld is reduced to
below the release point threshold
 RoHS Compliant
 Latching version available on special order basis
MAGNETIC SENSOR
Dimensions
inches (mm)
All tolerances ±0.005 (0.13) unless otherwise noted.
Open Collector
Sinking Block Diagram
Sensor Pocket
Applications
 Speed sensing
 Door interlock sensing
 Water fl ow sensing
Notes: These sensors require the use of an external pull-up resistor, the value of which is dependent on the supply voltage. See page 27 for recommendations.
Pull-up resistor should be connected between output (Green) and Vcc (Red).
Specifi cations
Part
Number
Operating
Voltage Range
(VDC)
Supply
Current
(mA max.)
Output
Output
Saturation Voltage
(mV max.)
Output
Current
(mA max.)
Operating
Temp Range
(°C)
Storage
Temp Range
(°C)
Operate
Point Gauss
(max.)
Release
Point Gauss
(min.)
Leads
Reverse Battery
Protection
MP101301
3.8 – 24 7.5 3-wire sink 400 25 -40 to 85 -40 to 85 245 60 24 AWG
x 150 mm
-30VDC
Specifi cations subject to change without notice.
8