User's Manual

Diagram 1
Keep panel at
horizontal Mounting panel
Upwards
Gradienter
4- 10mm
Ø
60mm
10mm
M6*50 mm
Ø m10*47 m
4-2.2 Operating Instruction
A. Insert one 23A 12V battery in the , the effective distance is
within 10 meters.
When user presses any function key (up, down, left, and right) of Remote
control,the TV bracket with TV will move to the corresponding direction, and
will stop when you loosen the key.
Remote control
B.
If any remote of our product was lost or damaged, you can
buy a new remote control with the same frequencies which produce
by our company and do following operation:
control
Changes or modifications not expressly approved by the party resp-
onsible for compliance could void the user's authority to operate the
equipment.
B.
A. Memory cleaning: Press coding key about 10 seconds, the memory
will clean after the LED indicator closed. (The memory is the coding
memory of the previous remote control).
Use new remote control: Press any key of remote control and the
coding key1-2seconds at the same time, Loosen remote control firstly,
Then loosen the coding key, Finally, you can operate the product with
new remote control.(Coding key ,Indicator, Please see diagram2).
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against ha-
rmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful inte-
rference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined b turning the interference by one or more of the fo-
llowing measures:
--Reorient or relocate the receiving antenna.
--increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
4-2.3 Notice
3. Installation Instruction
3-1. Be sure the wall to be mounted is solid enough and does not have rigid mat-
erial inside.Then,put the mounting panel on the wall,Horizontalize it and mark
hole locations.Drill holes on the wall at marked locations to 60~70mm depth and
10mm, Put to the holes, Then use ⑦
tighten them with anner. (Diagram 1)
Ø the ⑥ plastic wall plug (4pcs) Hexagon
flange wood screw
Warning:
Correct installation is extremely essential , and falls outside the
scope of responsibility of manufacturer . The user must pay atten-
tion to the weight of TV and TV wall mount, and only solid wall
can support the weight. Please comply with the installation instr-
uction of LCD/PDP to install them.
Warning:
2.Electric Specifications
2-1.Input Voltage/Current /Frequency, Output Current
A.
B.
Input Voltage/Current /Frequency: 100-240VAC/<0.65A/50~60Hz
Output Current:DC12V,2A
2-2.Motor
Item
Rated Voltage
Current(Not Load) Current (Rated Load)
Operating Temperature
Motor
DC12V
≤0.3 A ≤0.6 A
-20℃~50℃
(2) (5)