User's Manual

Funtion：Tuya APP+fingerprint
Fingerprint capacity：20pcs
Fingerprint reading speed≤0.5 Seconds
1.2 Product Technical Parameters
Matching products：padlock，traffic lock,U-shaped glass
lock,drawer lock,cabinet lock
Battery：Lithium battery
working temperature：-10℃-45℃
USB Charging：5v，Micro USB Interface
Working humidity：40％RH-90％RH
1.2 Click on the "Security Sensing" category on the left
1.3 Find the Door Lock (Bluetooth) and click.
1. Connect the APP
Before you do the following, make sure your phone's Bluetooth is
turned on and your phone and padlock are within a reasonable
distance. It is recommended to operate within 5 meters.
1.1 Click the "+" icon in the upper right corner of the app home page
1.5 Enter the Bluetooth search interface, the device name appears, click
"OK" to connect.
Search for "Tuya" APP in the application market and download it. Open
the APP.
1.4 Click “start Bluetooth distribution network”,At the same time place
your finger on the padlock fingerprint area and turn on Bluetooth
1.7 Bluetooth unlock, click the unlock button on the device interface to
unlock.
1.6 Prompt connection success
2.2 Delete fingerprint information
2. Fingerprint management
In the initial state, the device has no fingerprint information. Any finger
can unlock.
After entering the fingerprint successfully, you can unlock it with the
corresponding fingerprint. The green light is on and the buzzer sounds
when unlocking is successful. Failure lights up red.
management interface, click "Settings-Fingerprint Management", and
click the registered fingerprint -delete it.
2.1 Add fingerprint settings
Open the app, click the corresponding device on the homepage, enter the
Enter the device management interface and click lower right corner
Settings-Fingerprint Management-upper right corner “+”-click “user
password in the middle of the interface”-click to start collection. Place
your finger on the fingerprint area to start fingerprint recognition
according to the APP prompt. The sampling is successful, the blue light is
on, the red light is faulty, and the continuous sampling is successful 4
times, indicating that the entry is successful.
3. Fingerprint lock charging instructions
When the battery voltage is lower than 3.2 V, it will enter a low-voltage
protection state. No matter if you touch the fingerprint or the button, there
will be no response. Now you need to plug in USB to charge to restore
normal working status.
After unlocking operation, if the battery voltage is lower than 3.6V. The
low-voltage alarm time is about 5 s, the red light flashes once per second,
and the buzzer sounds.
4.1Click the home device ,enter the unlock interface ,click in the upper
right corner,enter the next interface 。
3.1 When charging, the red light is on; when fully charged, it lights up in
green.
4.2Click the remove device in the bottom,it will pop up the interface in the
bottom,click on the unbundling and remove the data,initialization successful.
3.2 Low voltage alarm
3.3 Low voltage protection:
4.Product initialization
Fingerprint
Padlock
User Manual
（Tuya app）