Quick Start Guide

Quick Start Guide
13
3 Web Configuration
This chapter provides a step-by-step configuration of the VTO, as well as how to register digital
indoor monitors (hereinafter referred to as the "VTH") into the VTO to realize its intercom function.
Follow the instructions below to get started.
● The snapshots are for reference only and slight differences might be found in the actual web
page of the VTO, depending on your model.
● You can download the configuration tool “VDPConfig” and use it to configure and update
multiple devices. For details, see the corresponding user's manual.
Initializing VTO
For the first time login, you need to initialize the VTO.
Step 1 Power on the VTO.
Step 2 Go to the default IP address (192.168.1.108) of the VTO in the browser address bar,
and then press the Enter key to go to the web page of the VTO.
● The user name is admin by default.
● Make sure that the IP address of the PC is on the same network segment as the
VTO.
Step 3 On the
Device Init
page, enter and confirm the password, and then click
Next
.
The password must consist of 8–32 non-blank characters and contain at least two
types of the following characters: Uppercase, lowercase, numbers, and special
characters (excluding ' " ; : &).