User's Manual

14
Table 4-5 System parameter description
Parameter
Description
Date Format
Select from one of the following:
 YYYY-MM-DD
 MM-DD-YYYY
 DD-MM-YYYY
Time Format
Select from one of the following:
 24-Hour
 12-Hour
System Time
Changing system time
might cause problems on video searching and
information publication. Turn off video recording and auto snapshot before
changing it.
Time Zone
Configure the time zone as needed.
Sync with
PC
Synchronize the VTO system time with your PC.
DST
Daylight saving time. If it is applicable to your area, you need to enable it, and
then configure DST type, start time and end time.
DST Type Select
Date
or
Week
as needed, and then configure the specific period.
Start Time
Configure the start time and end time of DST.
End Time
NTP Enable
Enable NTP and enter the IP address of the NTP server, and then the VTO
will syncronize time with the NTP server automatically.
NTP Server
Port
NTP server port number.
Interval VTO time update cycle. 30 minutes at most.
Maintenance
Define the time when the VTO will restart automatically.
Choose from Never, Monday, Tuesday, Wednesday, Thursday, Friday,
Saturday and Sunday.
SSH
You can connect debugging devices to the VTO through SSH protocol.
We recommend turning it off, and turn on security mode and outbound
service information protection. See "4.5 Security". Otherwise, the VTO might
be exposed to security risks and data leakage.
Emergency
Maintenance
Enable it for fault analysis and repair.
This function will occupy 8088 and 8087 ports.
NTP Enable
Enable NTP so that the device time will be automatically synchronized with
server.
Click Save.
Security