User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Local Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Logging In
- 3.3 Resetting the Password
- 3.4 Data Capacity
- 3.5 Configuring Video and Image
- 3.6 Configuring Face Detection
- 3.7 Configuring Network
- 3.8 Safety Management
- 3.9 User Management
- 3.10 Maintenance
- 3.11 Configuration Management
- 3.12 Upgrading System
- 3.13 Viewing Version Information
- 3.14 Viewing Logs
- 4 Smart PSS Lite Configuration
- Appendix 1 Important Points of Face Registration
- Appendix 2 Cybersecurity Recommendations
44
●
The username cannot be the same with existing account. The username consists of up
to 31 characters and only allows for numbers, letters, underscores, midlines, dots, or @.
●
The password must consist of 8 to 32 non-blank characters and contain at least two
types of the following characters: Upper case, lower case, numbers, and special
characters (excluding ' " ; : &).
Set a high-security password by following the password strength prompt.
Figure 3-21 Add user
Step 3 Click
OK
.
Only admin account can change password and admin account cannot be deleted.
3.9.2 Adding ONVIF Users
Open Network Video Interface Forum (ONVIF), a global and open industry forum that is established
for the development of a global open standard for the interface of physical IP-based security
products, which allows the compatibility from different manufactures. ONVIF users have their
identities verified through ONVIF protocol. The default ONVIF user is admin.
Procedure
Step 1 On the home page, select
User Mgmt.
>
Onvif User
.
Step 2 Click
Add
and then configure parameters.