User's Manual

30
Modifying alarm linkage parameter Figure 4-9
Table 4-2 Alarm linkage parameter description
Parameter Description
Alarm Input You cannot modify the value. Keep it default.
Name Enter a zone name.
Alarm Input Type
There are two options: NO and NC.
If alarm input type of the alarm device you purchased is NO, then you
should select NO; otherwise you should select NC.
Fire Link Enable
If fire link is enabled, the standalone
will output alarms when fire
alarms are triggered. The alarm details will be displayed in the alarm
log.
Alarm output and access link are NO by default if fire link is enabled.
Alarm Output
Enable
The relay can output alarm information (will be sent to the
management platform) if the Alarm Output is enabled.
Duration (Sec.) The alarm duration, and the range is 1–300 seconds.
Alarm Output
Channel
You can select an alarm output channel according to the alarming
device that you have installed. Each alarm device can be regarded as
a channel.
Access Link
Enable
After the Access Link is enabled, the standalone will be normally open
or normally closed when there are input alarm signals.
Channel Type
There are two options: NO and NC.
Click OK, and then the configuration is completed. Step 3