User's Manual

6
User Management
You can add new users, view the user list, admin list, and modify the super password on the
User interface.
2.7.1 Adding a New User
Select on the standby interface, and then tap OK.
Log in as the administrator, and then select User Management > New User.
This section uses a device with the fingerprint function. Differences on the interfaces
might be found on the actual interfaces.
Add a new user
Configure the parameters.
Table 2-3 Parameter description
Paramete
r
Description
No.
Each user ID is unique. It can be 18 characters of numbers, letters, or the their
combination. For example employee ID number.
Name
You can enter names with at least 10 Chinese characters or 32 characters
(including numbers, symbols, and letters).
Fingerprin
t
Each user can add up to 3 fingerprints. Follow the on-screen instructions and voice
prompt to add a fingerprint.
You can enable the Duress FP function under each fingerprint. After the duress
alarm function is enabled, you can trigger an alarm by using the duress fingerprint
to unlock the door. See the user's manual for details.
 We do not recommend setting the first fingerprint as the duress fingerprint.
 Only certain models support the fingerprint function.
Card
You can register five cards for each user. On the card registration interface, swipe
your card, and then the card information will be read by the device.
You can enable the duress card function on the card registration interface. After the
duress alarm function is enabled, you can trigger an alarm by using the duress card
to unlock the door.
PWD
The door unlocking password. The maximum length of the ID digits is 8.