User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Local Operations
- 2.1 Basic Configuration Procedure
- 2.2 Common Icons
- 2.3 Standby Screen
- 2.4 Initialization
- 2.5 Logging In
- 2.6 Network Communication
- 2.7 User Management
- 2.8 Access Management
- 2.9 Attendance Management
- 2.10 System
- 2.11 USB Management
- 2.12 Configuring Features
- 2.13 Unlocking the Door
- 2.14 Viewing Unlock Logs
- 2.15 System Information
- 3 Web Operations
- 3.1 Initialization
- 3.2 Logging In
- 3.3 Resetting the Password
- 3.4 Configuring Door Parameter
- 3.5 Intercom Configuration
- 3.6 Configuring Time Sections
- 3.7 Data Capacity
- 3.8 Configuring Video and Image
- 3.9 Configuring Face Detection
- 3.10 Configuring Network
- 3.11 Safety Management
- 3.12 User Management
- 3.13 Configuring Voice Prompts
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrading System
- 3.17 Viewing Version Information
- 3.18 Viewing Logs
- 4 Smart PSS Lite Configuration
- Appendix 1 Important Points of Intercom Operation
- Appendix 2 Important Points of QR Code Scanning
- Appendix 3 Important Points of Fingerprint Registration Instructions
- Appendix 4 Important Points of Face Registration
- Appendix 5 Cybersecurity Recommendations
5
●
If you forget the administrator password, send a reset request to your registered e-mail address.
●
The password must consist of 8 to 32 non-blank characters and contain at least two types of
characters among upper case, lower case, number, and special character (excluding ' " ; : &).
2.5 Logging In
Log in to the main menu to configure the Access Controller. Only admin account and administrator
account can enter the main menu of the Access Controller. For the first-time use, use the admin
account to enter the main menu screen and then you can create the other administrator accounts.
●
admin account: Can log in to the main menu screen of the Access Controller, but has no door
access permission.
●
Administration account: Can log in to the main menu of the Access Controller and has door
access permissions.
Step 1 Press and hold the standby screen for 3 seconds.
Step 2 select a verification method to enter the main menu.
●
Face: Enter the main menu by face recognition.
●
Fingerprint: Enter the main menu by using fingerprint.
Fingerprint function is only available for the fingerprint model of Access Controller.
●
Card Punch: Enter the main menu by swiping card.
Card Punch function is only available for the card swiping model of Access Controller.
●
PWD: Enter the user ID and password of the administrator account.
●
admin: Enter the admin password to enter the main menu.
2.6 Network Communication
Configure the network, serial port and Wiegand port to connect the Access Controller to the
network.
The serial port and the wiegand port might differ depending on models of Access Controller.
2.6.1 Configuring IP
Set IP address for the Access Controller to connect it to the network. After that, you can log in to the
webpage and the management platform to manage the Access Controller.
Step 1 On the
Main Menu
, select
Connection
>
Network
>
IP Address
.
Step 2 Configure IP Address.