User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Local Operations
- 2.1 Basic Configuration Procedure
- 2.2 Common Icons
- 2.3 Standby Screen
- 2.4 Initialization
- 2.5 Logging In
- 2.6 Network Communication
- 2.7 User Management
- 2.8 Access Management
- 2.9 Attendance Management
- 2.10 System
- 2.11 USB Management
- 2.12 Configuring Features
- 2.13 Unlocking the Door
- 2.14 Viewing Unlock Logs
- 2.15 System Information
- 3 Web Operations
- 3.1 Initialization
- 3.2 Logging In
- 3.3 Resetting the Password
- 3.4 Configuring Door Parameter
- 3.5 Intercom Configuration
- 3.6 Configuring Time Sections
- 3.7 Data Capacity
- 3.8 Configuring Video and Image
- 3.9 Configuring Face Detection
- 3.10 Configuring Network
- 3.11 Safety Management
- 3.12 User Management
- 3.13 Configuring Voice Prompts
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrading System
- 3.17 Viewing Version Information
- 3.18 Viewing Logs
- 4 Smart PSS Lite Configuration
- Appendix 1 Important Points of Intercom Operation
- Appendix 2 Important Points of QR Code Scanning
- Appendix 3 Important Points of Fingerprint Registration Instructions
- Appendix 4 Important Points of Face Registration
- Appendix 5 Cybersecurity Recommendations
25
2.13.1 Unlocking by Cards
Place the card at the swiping area to unlock the door.
2.13.2 Unlocking by Face
Verify the identity of an individual by detecting their faces. Make sure that the face is centered on the
face detection frame.
2.13.3 Unlocking by User Password
Enter the user ID and password to unlock the door.
Step 1 Tap on the standby screen.
Step 2 tap
PWD Unlock
, and then enter the user ID and password.
Step 3 Tap
Yes
.
2.13.4 Unlocking by Administrator Password
Enter only the administrator password to unlock the door. The access controller only allows for one
administrator password. Using administrator password to unlock the door without being subject to
user levels, unlock modes, periods, holiday plans, and anti-passback except for normally closed door.
One device allows for only one admin password.
Prerequisites
The administrator password was configured. For details, see "2.7.3 Configuring
Administrator Password".
Administrator password cannot be used to unlock the door status is set to NC.
Procedure
Step 1 Tap on the standby screen.
Step 2 Tap
Admin PWD
, and then enter the admin password.
Step 3 Tap .
2.13.5 Unlocking by QR code
Step 1 On the standby screen, tap .
Step 2 Place your QR code in front of the lens.
2.13.6 Unlocking by Fingerprint
Place you finger on the fingerprint scanner. This function is only available on the Access Controller