User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Local Operations
- 2.1 Basic Configuration Procedure
- 2.2 Common Icons
- 2.3 Standby Screen
- 2.4 Initialization
- 2.5 Logging In
- 2.6 Network Communication
- 2.7 User Management
- 2.8 Access Management
- 2.9 Attendance Management
- 2.10 System
- 2.11 USB Management
- 2.12 Configuring Features
- 2.13 Unlocking the Door
- 2.14 Viewing Unlock Logs
- 2.15 System Information
- 3 Web Operations
- 3.1 Initialization
- 3.2 Logging In
- 3.3 Resetting the Password
- 3.4 Configuring Door Parameter
- 3.5 Intercom Configuration
- 3.6 Configuring Time Sections
- 3.7 Data Capacity
- 3.8 Configuring Video and Image
- 3.9 Configuring Face Detection
- 3.10 Configuring Network
- 3.11 Safety Management
- 3.12 User Management
- 3.13 Configuring Voice Prompts
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrading System
- 3.17 Viewing Version Information
- 3.18 Viewing Logs
- 4 Smart PSS Lite Configuration
- Appendix 1 Important Points of Intercom Operation
- Appendix 2 Important Points of QR Code Scanning
- Appendix 3 Important Points of Fingerprint Registration Instructions
- Appendix 4 Important Points of Face Registration
- Appendix 5 Cybersecurity Recommendations
29
Figure 3-2 Reset password
●
Up to two security codes will be generated when the same QR code is scanned. If the
security code becomes invalid, refresh the QR code and scan again.
●
After you scan the QR code, you will receive a security code in your linked e-mail
address. Use the security code within 24 hours after you receive it. Otherwise, it will
become invalid.
●
If the wrong security code is entered in a row, the administrator account will be frozen
for 5 minutes.
Step 4 Enter the security code.
Step 5 Click
Next
.
Step 6 Reset and confirm the new password.
The password should consist of 8 to 32 non-blank characters and contain at least two of
the following types of characters: upper case, lower case, number, and special character
(excluding ' " ; : &).
Step 7 Click
OK
.
3.4 Configuring Door Parameter
Configure the access control parameters.
Step 1 Log in to the webpage.
Step 2 Select
Door Parameter
.