User's Manual

31
Parameter Description
Duress Alarm
An alarm will be triggered when a duress card or duress
password is used to unlock the door.
Door Sensor
Intrusion and overtime alarms can be triggered only after
Door Sensor
is enabled.
Intrusion Alarm
When
Door Sensor
is enabled, an intrusion alarm will be
triggered if the door is opened abnormally.
Overtime Alarm
A timeout alarm will be triggered if the door remains
unlocked for longer time than the
Timeout (Sec)
.
Anti-passback Alarm
Users need to verify their identities both for entry and exit;
otherwise an alarm will be triggered. It helps prevents a card
holder from passing an access card back to another person so
they gain entry. When anti-passback is enabled, the card
holder must leave the secured area through an exit reader
before system will grant another entry.
●
If a person enters after authorization and exits without
authorization, an alarm will be triggered when they
attempt to enter again, and access is denied at the same
time.
●
If a person enters without authorization and exits after
authorization, an alarm will be triggered when the they
attempt to enter again, and access is denied at the same
time.
Step 3 Configure the opening method.
●
Unlock by Period
1. In the
Opening Method
list, select
Unlock by Period
, and then click .
Figure 3-4 Time section parameter
2. Configure the time and the opening method for a time section. You can configure
up to four time sections for a single day.
3. Select
Apply to the whole week
to copy the defined time to the rest of days.
●
Group Combination
1. In the
Opening Method
list, select
Group Combination
, and then click .
2. Click
Add
.
3. Select an unlocking method in the
Opening Method
list., and enter the number of
valid users.
If the number of valid users is 2, and there are 3 users in the defined user list. Two
users in the list are required to grant access.