User's Manual

19
 Select Serial Input when external devices that are with card reading and writing functions
are connected to the access controller. Serial Input is selected to enable access card
information to be sent to the access controller and the management platform.
 For access controllers with face recognition, card reading and writing functions, if you
select Serial Output, access controller will send lock/unlock information to other access
controllers. There are two types of lock/unlock information: User ID and card number.
 Select OSDP Input when card reader of OSDP protocol is connected to the access controller.
The access controller can send card information to the management platform.
2.10.5 Wiegand Configuration
Only model J access controllers support this function.
Select Wiegand Input or Wiegand Output accordingly.
Log in to the Main Menu interface.
Select Connection > Wiegand.
Wiegand
 Select Wiegand Input when an external card swipe mechanism is connected to the access
controller.
 Select Wiegand Output when the access controller works as a reader that can be
connected to other controllers. See Table 2-7.
Table 2-7 Wiegand output
Parameter
Description
Wiegand Output Type
The Wiegand Output Type determines the card number or the digit of
the number that can be recognized by the access controller.
Wiegand26, three bytes, six digits.
Wiegand34, four bytes, eight digits.
Wiegand66, eight bytes, sixteen digits.
Pulse Width
Set the valur as needed.
Pulse Interval
Output Data Type
User ID: If User ID is selected, and then user ID will be output.
Card No.: If Card No. is selected, and then card number will be
output.