User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
22
Parameter
Description
Temp Correction Duration (ms): When monitoring the
temperature, the access controller will take the temperature value
after the time defined by this parameter.
Only certain models support this parameter.
High Temp Threshold: Set the temperature threshold. The
monitored body temperature will be judged as high temperature
if it is greater than or equal to the set value.
Only certain models support this parameter.
Max/Min temperature: Set the temperature range you need. If
the monitored temperature is lower than the lower limit, it will
prompt that the temperature is too low; if higher than the upper
limit, it will prompt that there is a heat source interfering with
the function.
Temp Correction Value: This parameter is for testing. The
difference of the temperature monitoring environment might
cause the temperature
deviation between the monitored
temperature and the actual temperature. You can select multiple
monitored samples for testing, and then correct the temperature
deviation by this parameter a
ccording to the comparison
between the monitored temperature and the actual temperature.
For example, if the monitored temperature is 0.5°C lower than
the actual temperature, the correction value is set to 0.5°C; if the
monitored
temperature is 0.5°C higher than the actual
temperature, the correction value is set to -0.5°C.
Temp Monitoring Mode:
Only certain models support this parameter.
Auto: Uses a face heat map for face recognition; if heat maps
are not found, it will automatically change to calibration mode.
Thermogram: Uses only a heat map for face recognition and
temperature monitoring.
Calibration:
Uses a white light image of a face for face
recognition, and then extract and apply the coordinates on the
face heat map for temperature monitoring.
Temp Unit: Select ° C or ° F.
Evn Compensation Value: This value will be adde
d to the
monitored environment temperature.
Only certain models support this parameter.
Temperature Strategy:
Only certain models support this parameter.
Maximum: Take the highest temperature as the result.