User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
24
2.11.7 Screen Settings
You can set the screen saver time and screen off time.
Log in to the Main Menu interface.
Select System > Screen Settings.
Screen settings
2.11.8 Restore to Factory Settings
Data will be lost if you restore the access controller to the factory settings.
After the access controller is restored to the factory settings, IP address will not be
changed.
You can select whether to retained user information and logs.
You can select to restore the access controller to the factory settings with all user
information and device information deleted.
You can select to restore the access controller to the factory settings with user information
and device information retained.
2.11.9 Reboot
Log in to the Main Menu interface.
Select System > Reboot, and the access controller will be rebooted.
USB
Make sure that the USB is inserted to the access controller before exporting user
information and updating.
During exporting or updating, do not pull out the USB or operate the access controller;
otherwise the exporting or updating will fail.
Export information from one access controller to the USB, and then import it to another
access controller. Different models support different types of information, such as faces
and fingerprints.