User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
35
Login
Open IE web browser, enter the IP address of the access controller in the address bar,
and press Enter.
Use browser newer than IE 8, otherwise you might not log in to the web.
Make sure that the computer used to log in to the web is in the same LAN with the
access controller.
The default IP address is 192.168.1.108.
Login
Enter the user name and password.
The default administrator name is admin, and the password is the login password
after initializing the access controller. Change the administrator password regularly
and keep it properly.
If you forget the administrator login password, you can click Forget Password? to
reset it. See "3.3 Resetting the Password."
Click Login.
Resetting the Password
When resetting the password of the admin account, your email address will be needed.
Click Forgot password? on the login interface.