User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
40
Change alarm linkage parameters
Table 3-2 Alarm linkage parameter description
Parameter
Description
Alarm Input
You cannot modify the value. Keep it default.
Name
Enter a zone name.
Alarm Input Type
If alarm input type of the alarm device you purchased is NO, then you
should select NO; otherwise you should select NC.
Fire Link Enable
If fire link is enabled the access controller will output alarms when fire
alarms are triggered. The alarm details will be displayed in the alarm
log.
Alarm intput and access link are NO by default if fire link is enabled.
Access Link Enable
If enabled, the access controller will be normally on or normally closed
when there are input alarm signals.
Channel Type
There are two options: NO and NC.
Click OK, and then the configuration is completed.
The configuration on the web will be synchronized with the configuration in the client if
the access controller is added to a client.
3.5.2 Alarm Log
You can view the alarm type and time range in the Alarm Log interface.
Log in to the web interface.
Select Alarm Linkage > Alarm Log.