User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
59
Sensitivity represents the ability of each grid to sense motion. The larger the value
is, the higher the sensitivity is.
Threshold is the condition of motion detection. When grid number reaches the
threshold, motion detection will be triggered. The smaller the value is, the more
likely the motion detection will be triggered.
When grid number is smaller than the threshold, green line will appear; when grid
number is more than the threshold, red line will appear. See Figure 3-34.
Click OK to finish the setting.
3.9.5 Volume Setting
Adjust the volume of the speaker or the beeping prompt.
Log in to the web interface.
Select Video Setting > Volume Setting.
Volume setting
3.9.6 Image Mode
Select indoor, outdoor or other according to where the access controller is installed.
Log in to the web interface.
Select Video Setting > Image Mode.
Indoor: The access controller is installed indoors.
Outdoor: The access controller is installed outdoors.
Other: The access controller is installed at places with backlights, such as hallways.
Image mode