User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
71
Maintenance
You can make the access controller reboot itself in idle time to improve the running speed of
the access controller. You need to set the auto reboot date and time.
Log in to the web interface.
Select Maintenance.
Set the auto reboot time, and then click OK.
Maintenance
For example, the access controller will reboot at 2 O’clock in the morning every Tuesday.
Click Reboot Device, the access controller will reboot immediately.
Configuration Management
When more than one access controller needs the same configuration, you can configure
parameters for them by importing or exporting configuration files.
3.15.1 Exporting Configuration File
You can export the configuration file of the access controller for backup.
Log in to the web interface.
Select Config Mgmt. on the navigation bar.
Configuration management
Click Export configuration to save the configuration file locally.
IP information of the access controller will not be exported.