User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
72
3.15.2 Importing Configuration File
You can import the configuration file that is exported from an access controller to another
access controller with the same model.
Log in to the web interface.
Select Config Mgmt. on the navigation bar.
On the configuration management interface, click Browse to select the configuration
file that you want to import, and then click Import configuration.
The access controller will reboot after importing configuration file.
3.15.3 Default
Restore Factory: Reset all the data and configuration of the access controller.
Restore Factory (Save user & log): Reset all data and configuration, except for user
information and logs.
Upgrade
Export the configuration file for backup before upgrade, and then import it after the
upgrade is completed.
Make sure that the upgrade file has been obtained. You can get it from technical support.
Do not disconnect the power or network, or reboot or shutdown the access controller
during upgrade.
Log in to the web interface.
Select Upgrade on the navigation bar.
On the Upgrade interface, click Browse to select the upgrade file, and then click
Upgrade.
Upgrade
If the upgrade is succeeded, the system pops up a message indicating that the upgrade
is completed. If the upgrade is failed, there will be corresponding prompts.