User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 System Operations
- 3 Web Operations
- 3.1 Initialization
- 3.2 Login
- 3.3 Resetting the Password
- 3.4 Door Parameter
- 3.5 Alarm Linkage
- 3.6 Talkback Setting
- 3.7 Time Section
- 3.8 Data Capacity
- 3.9 Video Setting
- 3.10 Face Detection
- 3.11 Network Setting
- 3.12 Safety Management
- 3.13 User Management
- 3.14 Maintenance
- 3.15 Configuration Management
- 3.16 Upgrade
- 3.17 Version Information
- 3.18 Online User
- 3.19 System Log
- 3.20 Fusion Calibration
- 3.21 Advanced
- 3.22 Exit
- 4 SmartPSS AC Configuration
- 5 FAQ
- Appendix 1 Notes of Face Recording/Comparison
- Appendix 2 Cybersecurity Recommendations
78
Auto search
Enter the network segment, and then click Search.
A search result list will be displayed.
Select access controllers that you want to add to the SmartPSS AC, and then click Add.
The Login information dialog box will be displayed.
Enter the username and the login password to login.
You can see the added access controller on the Devices interface.
Select an access controller, click Modify IP, and you can modify the access controller’s IP
address. For details about IP address modification, see SmartPSS AC user manual.
4.2.2 Manual Add
You can add access controllers manually. You need to know IP addresses and domain names of
access controllers that you want to add.
Log in to SmartPSS AC.
Click Device Manager at the lower left corner.
Click Add on the Devices interface, and the Manual Add interface will be displayed.